Last Modified: 11-29-2007 1.6 A
Service Category: Suspension Section: Rear Suspension
Model Year: 2008 Model: Sequoia Doc ID: RM000003F6G000X
Title: REAR SUSPENSION: REAR STABILIZER BAR: REMOVAL (2008 Sequoia)

REMOVAL

1. REMOVE EXHAUST PIPE ASSEMBLY TAIL (for 3UR-FE) 3UR-FE INTAKE / EXHAUST: EXHAUST PIPE: REMOVAL (2008 Sequoia)+

2. REMOVE EXHAUST PIPE ASSEMBLY TAIL (for 2UZ-FE) 2UZ-FE INTAKE / EXHAUST: EXHAUST PIPE: REMOVAL (2008 Sequoia)+

3. REMOVE PROPELLER SHAFT ASSEMBLY (for 2WD)

DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 2WD): REMOVAL (2008 Sequoia)

4. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD): REMOVAL (2008 Sequoia)+

5. REMOVE TRANSFER HEAT INSULATOR (for 4WD) DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD): REMOVAL (2008 Sequoia)+

6. REMOVE PROPELLER SHAFT ASSEMBLY (for 4WD) DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD): REMOVAL (2008 Sequoia)+

7. REMOVE REAR STABILIZER LINK ASSEMBLY LH



(a) Remove the 2 nuts and the rear stabilizer link.

HINT:

If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.

8. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.

9. REMOVE REAR STABILIZER BRACKET

(a) Remove the 4 bolts and 2 brackets.

10. REMOVE REAR STABILIZER BAR

(a) Remove the rear stabilizer bar from the vehicle.

11. REMOVE REAR STABILIZER BUSH

(a) Remove the 2 bushes from the rear stabilizer bar.